Bend Bench - Conduit Bending

A 6" offset at 30°: 12" between the marks, 1-1/2" of shrink. Type the height, tap the angle, mark the pipe. Bend Bench is 12 calculators for electricians and apprentices: conduit bending marks and everyday electrical math, built for the job site and fully offline. 8 bends, each with a diagram Every bend draws the pipe with numbered marks and the distances between them. • Offset, with near or far critical bend and a distance from the pipe end • Rolling Offset: rise and roll in, true offset and pipe rotation out • 3-Point Saddle and 4-Point Saddle • 90° Stub-Up from your bender's take-up, with gain and cut length when you add the radius and second leg • Kick • Back-to-Back 90 • Parallel Offsets for two to six conduits Marks are measured along the pipe, and each mark is rounded on its own: to 1/16" or 1/8", or to whole millimeters in metric. 4 electrical calculators • Ohm's Law: enter any…