BendMark: EMT Bender Offset

Stand at the bender, enter two numbers, get the mark. BendMark gives you the distance from the end of the pipe to every bend mark, in sixteenths of an inch, so you can find it on your tape without converting anything. Works with no signal. Nothing is fetched. FIFTEEN BENDS • Offset, rolling offset and parallel offset, evenly spaced or measured pipe by pipe for a rack of mixed sizes • Matching offset and kick: the angle that lines up with a pipe already bent, by the gap between its marks or by its rise • 3-point and 4-point saddles • 90° stub-up, back-to-back 90° and kick with 90° • Kick, parallel kick and matching kick • Compound 90° around a round, square or rectangular obstruction • Offset to fit: finish at a known length, and it says what to cut • Segment bend, for a large radius in many shots • Concentric 90°, for a bank of pipes round one corner YOUR BENDER, YOUR NUMBERS Pick…