Condbend: Bend Calculator

Condbend is a conduit bending and electrical calculator built for the people who actually bend pipe. FIELD NUMBERS, NOT CALCULATOR NUMBERS Ask an electrician for a 4" offset at 30 degrees and you get "marks 8 inches apart, shrink 1 inch." Most apps answer 8.000 and 0.268. Condbend shows the traditional field-table number first, with the exact trigonometric value next to it, so you can trust it without translating it. BENDING - Offset — marks, shrink, any angle - 3-point and 4-point saddle - Kick, and kick combined with a 90 - Rolling offset — rise plus roll to true offset - Segmented 90 — large radius in N shots - 90 stub-up — height minus take-up Every bend comes with a mark-the-pipe diagram drawn from the same geometry the math used, so what you see is what you measured. ELECTRICAL - Ohm's law - Voltage drop, single and three phase, copper and aluminium - Minimum wire size for a…